Gecko® 792 PROCOAT HD Rust Inhibitor

• Aircraft parts
• Battery terminals
• Bearings
• Cables & chains
• Hose assemblies
• Interior vehicle doors
• Metal parts
• Pulleys
• Pumps

1. Shake can vigorously for one minute after mixing ball begins to rattle.
2. Clean surface to bare metal.
3. Spray even coat over entire surface. It is needed; second coat may be applied in 5 minutes.
4. Coating will set up in 2 to 3 hours.

Handle with care. This is a pressurized container — do not puncture or burn, even after use.
Do not use if the spray button is missing or damaged. Avoid spraying onto open flames, sparks, or any incandescent materials.
Do not smoke while applying this product or until treated surfaces are completely dry.
Keep containers away from cutting, welding, soldering, drilling, or grinding operations, and from all sources of heat or ignition.
Ensure that all handling equipment is properly grounded to prevent static discharge.
Do not reuse empty containers. Avoid prolonged or repeated skin contact.
Use only in well-ventilated areas and wear appropriate personal protective equipment.
Wash hands and exposed skin thoroughly after use and maintain good industrial hygiene practices.

Store in a cool, dry, well-ventilated, and secure area.
Pressurized container protect from direct sunlight and do not expose to temperatures above 50°C (122°F).
Do not puncture, crush, or incinerate containers.
Keep away from open flames, heat, sparks, and other sources of ignition.
This product may accumulate static electricity that could cause a spark and ignite vapors.
Prevent electrostatic build-up through proper bonding and grounding procedures.
Keep containers tightly sealed in their original packaging.
Store away from incompatible materials (refer to Section 10 of the SDS).
Keep out of reach of children.

Dispose of contents and empty containers in accordance with local, regional, and national regulations.
Refer to the product’s Safety Data Sheet (SDS) for specific disposal recommendations.